Exhaust putty - EXHSTREPCOMPD-CAN-200G - 1

Exhaust putty

Name: Exhaust putty
Brand: Würth
SKU: 0890100046

Exhaust sealant
EXHSTREPCOMPD-CAN-200G

Art.-no. 0890100046

EAN 4011231819459

All versions

Similar products

Prices for customers after login

Exhaust putty

Art.-no. 0890100046

Prices for customers after login

Quantity

x 1 pcs

Exclusively for trade customers

Login/Register
Call customer service: +66 2170 5099

Small holes and cracks in the silencer system can be easily and permanently repaired so that they are gas-tight.

Extremely heat resistant

Resistant to large temperature fluctuations

No need to weld or to remove the silencer

Notice

For quicker curing, leave the engine to idle at low speed for around quarter of an hour.

The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting with deliberate intent. We ensure the consistent quality of our products. We reserve the right to make technical changes and further develop products.

Product information

Würth Catalogue

Datasheets(X)

Certificates/ Documents

Application area

Ideally suited for repairing cracks and holes in exhaust systems.

Instructions

1. Remove loose dirt and rust using a wire brush.

2. Then let the engine run for a short time in order to warm up the exhaust system.

3. Wet the area to be repaired and, with wet hands, cover the holes and cracks and surrounding areas with exhaust putty. The paste should be smoothed outwards.

Weight of content	200 g
Colour	Grey
Smell/fragrance	Odourless
Shelf life from production	12 Month
Max. temperature resistance	800 °C
Density	1.99 g/cm³
Density conditions	at 20°C

Suitable glove:

Product

Description

Nitrile chemical protective glove With cotton velour finish inside

Description:

Permeation level: 6

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Measured breakthrough time

Permeation level

< 10 min

≥ 10 min

≥ 30 min

≥ 60 min

≥ 120 min

≥ 240 min

≥ 480 min

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.